Accura 48HTR (Plastic / Photopolymer)

Get quotes for parts in Accura 48HTR
This is a limited version. For full material information REGISTER FOR FREE or LOG IN to the Additively Application



3D Systems


With thermal treatment
Automative Testing: under the hood; fluid flow and visualisation; intake manifolg design analysis and verification; cooland flow analysis; heating air duct models; transmission fluid flow analysis. Electronic controls prototypes. Aerospace wind tunnel models. Temperature resistant to 130°C (266 °F); high humidity and moisture resistance. Fast recoating and cleaning.

State of starting material


Properties, applications and appearance

Field of application

Rapid Prototyping

Register for free or Log in
for more information


Manufacturing process

Parts are built from a liquid photopolymer in a vat which is selectively cured by light-activated polymerization. Synonyms: SLA

Physical, mechanical and thermal properties

Physical Properties

specific density: 1.23 g/cm3

Mechanical Properties

ultimate tensile strenght: 64 - 67 MPa
tensile modulus (Young's / E- ): 2,800 - 3,980 MPa
flexural modulus: 2,760 - 3,400 MPa
flexural strenght: 105 - 118 MPa

Register for free or Log in
for more information

Data source: 3D Systems

ATTENTION: The presented values are provided by the material manufacturers and are only indicative. Realized material properties may differ from these value for several reasons. Additively does not guarantee the correctness of this information in any way.